Part Number Hot Search : 
VGB8084A EUA2313B R5110510 7809A S21190HR D5141M R7200406 6KE12
Product Description
Full Text Search
 

To Download PCM-4153FZ2-L0A2E Datasheet File

  If you can't view the Datasheet, Please click here to try to view without PDF Reader .  
 
 


  Datasheet File OCR Text:
 PC/104 CPU Modules
PCM-4153
NEW
Clear CMOS LAN 2 LAN 1 USB USB IDE LIN-out 4 COM port LPT con Inverter con LCD con Standby power con Battery Pin Power con
AMD LX800 PC/104-Plus Module, w/ Onboard Memory/Flash and Wide Temperature Range Features
AMD low power LX800/500 MHz Processor Supports dual 10/100 Mbps Ethernet 1 GB Flash & 512MB DDR memory onboard Supports three RS-232, one RS-232/422/485, and four USB 2.0 ports Supports Embedded Software API and Utility
Software APIs:
SMBus H/W Monitor Brightness Watchdog GPIO Backlight On/Off
KB/MS Line-in/MIC
RS422/485
Utility:
BIOS flash Monitoring
Specifications
CPU 2nd Cache Memory System Chipset BIOS System Memory Power Management SSD Flash Watchdog Timer Expansion Interface Battery I/O Interface USB Audio GPIO Chipset Speed Interface Chipset Memory Size Resolution Dimensions (L x W) Weight Operating Temperature Operating Humidity Power Supply Voltage Power Consumption AMD GeodeTM LX800, 500 MHz 128 KB on processor AMD Geode LX800 AWARD(R) 4-Mbit Flash BIOS 512 MB DDR333 SDRAM onboard APM 1.2 1 GB Flash Onboard 255-level interval timer, setup by software. 104-pin 16-bit PC/104 module connector and 120-pin PCI PC/104-Plus module connector Lithium 3 V/196 mAH 1 x EIDE, 1 x LPT, 1 x RS-232/422/485, 3 x RS232, 1 x K/B, 1 x Mouse 4 x USB 2.0 Supports AC97 audio stereo sound 8-bit general purpose Input/Output Intel 82551ER 10/100 Mbps 2 x internal box header AMD Geode LX800 Optimized Shared Memory Architecture, supports 64 MB frame buffer using system memory CRT display mode: pixel resolution up to 1920 x 1440 x 32 bpp at 85 Hz, 1600 x 1200 x 16 bpp at 100 Hz and up to 1024 x 768 x 32 bpp at 60 Hz for TFT LCD LCD Interface: 18/24 bit TTL interface Dual simultaneous display: CRT + LCD 96 mm x 115 mm 0.162 kg (with heat sink) 0 ~ 60 C (32 ~ 140 F) 0% ~ 90% relative humidity, non-condensing AT: 5V only to boot up (12 V is optional for LCD inverter and add on card) (Geode LX800, 256 MB DDR333) Max (Test in HCT): +5 V @ 1.51 A, +12 V @ 0.1 A Typical (WinXP Idle Mode): +5 V @ 1.35 A, +12 V @ 0.1 A
General
I/O
Ethernet
Display
Mechanical and Environmental
Power
Embedded Single Board Computers
All product specifications are subject to change without notice Last updated : 09-Nov-2009
PCM-4153 Board Diagram
Analog RGB
LCD Connector (DF13-40P)
VGA Box Header DDR SDRAM On-board 512MB
24 Bit TTL
AMD Geode LX800
DDR400
PC104 Connector
PCI to ISA Bridge IT8888G PC104+ Connector IDE On-board 1GB flash memory
Master IDE / DMA33
PCI BUS
10/100 LAN 82551ER 10/100 LAN 82551ER
USB 2.0 AC-Link
Box Header Box Header
USB 2.0 x 4 port ALC203
Slave
AMD Geode CS5536 / CS5535
GPIO
PCA9554
SMBus
BIOS COM1/COM2 COM3/COM4 Watchdog
LPC Bus
LPC Super I/O (SCH3114)
PS/2 KB&MS LPT Box Header
Ordering Information
Part No. CPU Chipset Onboard Memory 512 MB 512 MB 512 MB CRT Yes Yes Yes TTL LVDS LAN 2 FE 2 FE 2 FE USB2.0 4 4 4 RS-232 3 3 3 RS-232/ LPT/ Onboard 422/485 KB/MS Flash 1 1 1 Yes Yes Yes 1 GB 1 GB 1 GB Audio Yes Yes Yes PC/104+ connector Yes Yes Yes Thermal Solution Passive Passive Passive AMD PCM-4153F-L0A2E CS5536 LX800 AMD PCM-4153FZ-L0A2E CS5536 LX800 AMD PCM-4153FZ2-L0A2E CS5536 LX800 18/24 bit 18/24 bit 18/24 bit ETT Embedded Service OS WinCE 0 ~ 60 C (optional) WinCE -20 ~ 80 C (optional) WinCE -40 ~ 85 C (optional) Operating Temp.
Packing List
Part No. 1700003491 1700000918 1701400181 1703040157 1703060053 1700060202 1700005158 1700260250 1701440350 1700000898 1703100121 Description 1 x PCM-4153 SBC 1 x Wire AT Power cable 1 x Audio cable 1 x Four COM cable 1 x RS-422/485 COM cable 1 x Keyboard/Mouse cable 1 x Y cable (for KB/MS extension) 2 x Ethernet RJ-45 Conn. conversion cable 1 x LPT port cable 1 x IDE cable 1 x VGA cable 2 x USB cable (bracket type with two USB ports) 1 x Startup manual 1 x CD-ROM (Manual, Driver, Utility)
Online Download www.advantech.com/products
Value-Added Software Services
Software API: An interface that defines the ways by which an application program may request services from libraries and/or operating systems. Provides not only the underlying drivers required but also a rich set of user-friendly, intelligent and integrated interfaces, which speeds development, enhances security and offers add-on value for Advantech platforms. It plays the role of catalyst between developer and solution, and makes Advantech embedded platforms easier and simpler to adopt and operate with customer applications.
Software APIs
Control
General Purpose Input/Output is a flexible parallel interface that allows a variety of custom connections. It allows users to monitor the level of signal input or set the output status to switch on/off a device. Our API also provides Programmable GPIO, which allows developers to dynamically set the GPIO input or output status. SMBus is the System Management Bus defined by Intel(R) Corporation in 1995. It is used in personal computers and servers for low-speed system management communications. The SMBus API allows a developer to interface a embedded system environment and transfer serial messages using the SMBus protocols, allowing multiple simultaneous device control. I2C is a bi-directional two wire bus that was developed by Philips for use in their televisions in the 1980s. The I2C API allows a developer to interface with an embedded system environment and transfer serial messages using the I2C protocols, allowing multiple simultaneous device control.
Monitor
A watchdog timer (WDT) is a device that performs a specific operation after a certain period of time if something goes wrong and the system does not recover on its own. A watchdog timer can be programmed to perform a warm boot (restarting the system) after a certain number of seconds.
GPIO
Watchdog
SMBus
Hardware Monitor
The Hardware Monitor (HWM) API is a system health supervision API that inspects certain condition indexes, such as fan speed, temperature and voltage.
I2C
Hardware Control
The Hardware Control API allows developers to set the PWM (Pulse Width Modulation) value to adjust fan speed or other devices; it can also be used to adjust the LCD brightness.
Display
Power Saving
The Brightness Control API allows a developer to interface with an embedded device to easily control brightness. Brightness Control CPU Speed
Make use of Intel SpeedStep technology to reduce power power consumption. The system will automatically adjust the CPU Speed depending on system loading.
The Backlight API allows a developer to control the backlight (screen) on/off in an embedded device. Backlight System Throttling
Refers to a series of methods for reducing power consumption in computers by lowering the clock frequency. These APIs allow the user to lower the clock from 87.5% to 12.5%.
Software Utilities
The BIOS Flash utility allows customers to update the flash ROM BIOS version, or use it to back up current BIOS by copying it from the flash chip to a file on customers' disk. The BIOS Flash utility also provides a command line version and API for fast implementation into customized applications. The embedded application is the most important property of a system integrator. It contains valuable intellectual property, design knowledge and innovation, but it is easily copied! The Embedded Security ID utility provides reliable security functions for customers to secure their application data within embedded BIOS. The Monitoring utility allows the customer to monitor system health, including voltage, CPU and system temperature and fan speed. These items are important to a device; if critical errors happen and are not solved immediately, permanent damage may be caused. The eSOS is a small OS stored in BIOS ROM. It will boot up in case of a main OS crash. It will diagnose the hardware status, and then send an e-mail to a designated administrator. The eSOS also provides remote connection: Telnet server and FTP server, allowing the administrator to rescue the system. Flash Lock is a mechanism that binds the board and CF card (SQFlash) together. The user can "Lock" SQFlash via the Flash Lock function and "Unlock" it via BIOS while booting. A locked SQFlash cannot be read by any card reader or boot from other platforms without a BIOS with the "Unlock" feature.
BIOS Flash
eSOS
Embedded Security ID
Flash Lock
Monitoring
Embedded Single Board Computers
All product specifications are subject to change without notice Last updated : 09-Nov-2009


▲Up To Search▲   

 
Price & Availability of PCM-4153FZ2-L0A2E

All Rights Reserved © IC-ON-LINE 2003 - 2022  

[Add Bookmark] [Contact Us] [Link exchange] [Privacy policy]
Mirror Sites :  [www.datasheet.hk]   [www.maxim4u.com]  [www.ic-on-line.cn] [www.ic-on-line.com] [www.ic-on-line.net] [www.alldatasheet.com.cn] [www.gdcy.com]  [www.gdcy.net]


 . . . . .
  We use cookies to deliver the best possible web experience and assist with our advertising efforts. By continuing to use this site, you consent to the use of cookies. For more information on cookies, please take a look at our Privacy Policy. X